Endress+Hauser Proline Promag W 800 - Process

Proline Promag W 800 Technical data
Endress+Hauser 107
Compact version
• 10 to 200 Hz, 0.01 g
2
/Hz
• 200 to 2 000 Hz, 0.003 g
2
/Hz
• Total: 2.70 g rms
Remote version
• 10 to 200 Hz, 0.01 g
2
/Hz
• 200 to 2 000 Hz, 0.003 g
2
/Hz
• Total: 2.70 g rms
Shock half-sine, according to IEC 60068-2-27
• Compact version; order code for "Housing", option D "Compact IP68,type 6P,
polycarbonate"
6 ms 50 g
• Compact version; order code for "Housing", option M "Compact, polycarbonate"
6 ms 50 g
• Remote version; order code for "Housing", option N "Remote, polycarbonate"
6 ms 50 g
Rough handling shocks according to IEC 60068-2-31
Mechanical load Transmitter housing:
• Protect against mechanical effects, such as shock or impact
• Do not use as a ladder or climbing aid
Electromagnetic
compatibility (EMC)
As per IEC/EN 61326
Details are provided in the Declaration of Conformity.
This unit is not intended for use in residential environments and cannot guarantee
adequate protection of the radio reception in such environments.
The selection of a sensor with a steel housing is recommended for use in the vicinity
of electrical power supply lines with strong currents.
16.9 Process
Medium temperature range • 0 to +70 °C (+32 to +158 °F) for hard rubber, DN 50 to 900 (2 to 36")
• –20 to +50 °C (–4 to +122 °F) for polyurethane, DN 25 to 900 (1 to 36")
• –20 to +70 °C (–4 to +158 °F) for PTFE, DN 25 to 300 (1 to 12")
Hard rubber DN 50 to 900 (2 to 36") 0 to +70 °C (+32 to +158 °F)
Polyurethane DN 25 to 900 (1 to 36") –20 to +50 °C (–4 to +122 °F)
PTFE DN 25 to 300 (1 to 12") –20 to +70 °C (–4 to +158 °F)