Mounting procedure Proline Promag W 800
32 Endress+Hauser
For use in buried applications, Proline 800 - Advanced
• Only the remote version of the device with IP68 protection is suitable for use in
buried applications: order code for "Sensor option", options CD and CE.
• Pay attention to regional installation instructions.
Order code for "Sensor option", options CD, CE
For the use of the device in buried applications.
A0042646
6.2 Mounting the measuring device
6.2.1 Required tools
For Proline 800 transmitter
Torque wrench
For Proline 800 - Advanced transmitter
• Torque wrench
• For wall mounting:
Open-ended wrench for hexagonal screw max. M5
• For pipe mounting:
• Open-ended wrench AF 8
• Phillips head screwdriver PH 2
• For turning the transmitter housing (compact version):
• Phillips head screwdriver PH 2
• Torx screwdriver TX 20
• Open-ended wrench AF 7
For sensor
For flanges and other process connections: Use a suitable mounting tool.
6.2.2 Preparing the measuring device
1. Remove all remaining transport packaging.
2. Remove any protective covers or protective caps present from the sensor.
3. Remove stick-on label on the electronics compartment cover.
To Next Page
Loading...
