Endress+Hauser Proline Promag W 800 - Page 39

Proline Promag W 800 Mounting procedure
Endress+Hauser 39
The transmitter of the remote version can be mounted in the following ways:
• Wall mounting
• Pipe mounting
Wall mounting Proline 800 - Advanced
149 (5.85)
210.5 (8.29)
=
5.8 (0.23)
17 (0.67) =
14 (0.55)
5.8 (0.23)
A0020523
 5 Unit mm (in)
1. Drill the holes.
2. Insert wall plugs into the drilled holes.
3. Lightly screw in the securing screws.
4. Fit the transmitter housing over the securing screws and hook into place.
5. Tighten the securing screws.
6. Mount the antenna directly on the wall using the antenna bracket.
Post mounting Proline 800 - Advanced
NOTICE
Excessive tightening torque applied to the fixing screws!
Risk of damaging the plastic transmitter.
‣
Tighten the fixing screws as per the tightening torque: 2.5 Nm (1.8 lbf ft)
‣
Mount the antenna on the post using the antenna bracket.