Endress+Hauser Proline Promag W 800 - Turning the Transmitter Housing, Proline 800 - Advanced

Mounting procedure Proline Promag W 800
40 Endress+Hauser
ø 20…70
( 0.79…2.75)ø
~102 (~ 4.0)
4 x
SW 10
3 x
TX 25
A0029051
 6 Unit mm (in)
6.2.5 Turning the transmitter housing, Proline 800 - Advanced
To provide easier access to the connection compartment or display module, the transmitter
housing can be turned.
1.
2.
T20
A0044272
1. Loosen the fixing screws of the housing cover (when reassembling, pay attention to
the tightening torque →  42).
2. Open the housing cover.
ON
ON
1
2
3.
4.
5.
A0044274
3. Open the display module.
4. Push the ribbon cable out of the holder.
5. Disconnect the plug.