Endress+Hauser Proline Promag W 800 - Page 42

Mounting procedure Proline Promag W 800
42 Endress+Hauser
PUSH TO
REMOVE
TX 20
4 x
11.
PUSH TO
REMOVE
12.
A0044276
11. Loosen the fixing screws of the main electronics module (when reassembling, pay
attention to the tightening torque →  42).
12. Remove the main electronics module.
14.
15.
13.
4 mm
4 x
A0044277
13. Loosen the fixing screws of the transmitter housing (when reassembling, pay
attention to the tightening torque →  42).
14. Lift the transmitter housing.
15. Turn the housing to the desired position in increments of 90°.
Reassembling the transmitter housing
NOTICE
Excessive tightening torque applied to the fixing screws!
Risk of damaging the plastic transmitter.
‣
Tighten the fixing screws as per the tightening torque: 2.5 Nm (1.8 lbf ft)
‣
Mount the antenna on the post using the antenna bracket.
Step
→  40
Fixing screw Tightening torques
1 Housing cover 2.5 Nm (1.8 lbf ft)
9 Electronics module 0.6 Nm (0.4 lbf ft)
11 Main electronics module 1.5 Nm (1.1 lbf ft)
13 Transmitter housing 5.5 Nm (4.1 lbf ft)