Endress+Hauser Proline Promag W 800 - Operation; Wake on Touch

Operation Proline Promag W 800
72 Endress+Hauser
11 Operation
11.1 Wake on Touch
If you touch the display for 5 seconds the device shows measured values and status
information.
V
.
8.3
m /min
3
A0043867
Locking status
The device is locked via the hardware.
Bluetooth
Bluetooth function is enabled.
Device communication
Device communication is enabled.
Received signal strength (cellular radio)
Displays the received signal strength.
Failure
• A device error has occurred.
• Output signal is no longer valid.
Maintenance required
• Maintenance required.
• Output signal is still valid.
?
Out of specification
• Device is being operated outside the technical specification limits, e.g.
outside the process temperature range.
• Device is operated outside the configuration performed by the user, e.g.
maximum flow rate.
Diagnosis enabled
Output signal is valid.
Function check
• Device is in service mode, e.g. during a simulation.
• Output signal is temporarily invalid.