5 Group OPERATION Device Functions Proline Promass 80
16 Endress+Hauser
ACCESS CODE All data of the measuring system are protected against inadvertent change. Programming
is disabled and the settings cannot be changed until a code is entered in this function.
If you press the
OS key in any function the measuring system automatically goes to this
function and the prompt to enter the code appears on the display (programming
disabled).
You can enable programming by entering the personal code (Factory setting = 80, see
the DEFINE PRIVATE CODE function)
User input:
max. 4-digit number: 0...9999
! Note!
• The programming levels are disabled if you do not press a key within 60 seconds
following return to the HOME position.
• You can also disable programming in this function by entering any number (other than
the defined private code).
• The Endress+Hauser service organization can be of assistance if you lose your personal
code.
DEFINE PRIVATE CODE Use this function to define a personal code number for enabling programming.
User input:
max. 4-digit number: 0...9999
Factory setting:
80
! Note!
• If you define the personal code number = 0, the programming is always enabled.
• Programming has to be enabled before this code can be changed. When programming
is disabled the function can’t be changed, this precaution prevents others from
changing your personal code without your knowledge and consent.
STATUS ACCESS Use this function to check the access status for the function matrix.
Display:
ACCESS CUSTOMER (Parameterization enabled)
LOCKED (Parameterization disabled)
ACCESS CODE
COUNTER
Displays how often the customer code, service code or the digit “0” (code-free) has been
entered to gain access to the function matrix.
Display:
max. 7-digit number: 0...9999999
Factory setting:
0
Function description OPERATION
To Next Page
Loading...
