Endress+Hauser Proline Promass 80 - Group SENSOR DATA

Device Functions Proline Promass 80 16 Group SENSOR DATA
Endress+Hauser 57
16 Group SENSOR DATA
Function description SENSOR DATA
All sensor data, including calibration factor, zero point, nominal diameter, etc. are set at the factory. All the sensor's
parameter settings are saved on the S-DAT memory chip.
" Caution!
Under normal circumstances you should not change these parameter settings, because changes affect numerous functions
of the entire measuring facility in general, and the accuracy of the measuring system in particular. Consequently, most of
the functions described below can be accessed only by entering a special service code, which is not the same as your
private code number.
Contact the E+H service organization if you have any questions about these functions.
K-FACTOR This function shows the current calibration factor for the sensor.
Factory setting:
depends on nominal diameter and calibration
! Note!
If the service code is used to call this function, this value can be edited.
ZERO POINT This function shows the current zero-point correction value for the sensor.
User input:
max. 5-digit number: –99999...+99999
Factory setting:
depends on calibration
NOMINAL DIAMETER This function shows the nominal diameter for the sensor.
Factory setting:
depends on the size of the sensor
! Note!
If the service code is used to call this function, this value can be edited.
TEMPERATURE
COEFFICIENT KM
This function shows the temperature coefficient KM.
TEMPERATURE
COEFFICIENT KM 2
This function shows the temperature coefficient KM 2.
TEMPERATURE
COEFFICIENT KT
This function shows the temperature coefficient KT.
CALIBRATION
COEFFICIENT KD 1
This function shows the calibration coefficient KD 1.
CALIBRATION
COEFFICIENT KD 2
This function shows the calibration coefficient KD 2.