Endress+Hauser Proline Promass E 100 - Page 20

Proline Promass E 100
20 Endress+Hauser
Input values
(from automation system to
measuring device)
Analog Output module (fixed assignment)
• External pressure (slot 18)
• External temperature (slot 19)
•
External reference density (slot 20)
Discrete Output module (fixed assignment)
• Activate/deactivate positive zero return (slot 21)
• Perform zero point adjustment (slot 22)
Totalizer 1 to 3 (slot 15 to 17)
• Totalize
• Reset and hold
• Preset and hold
• Stop
• Operating mode configuration:
– Net flow total
– Forward flow total
– Reverse flow total
Heartbeat Verification module (fixed assignment)
Start verification (slot 23)

The range of options increases if the measuring device has one or more
application packages.
Supported functions • Identification & Maintenance
Simple device identification via:
– Control system
– Nameplate
• Measured value status
The process variables are communicated with a measured value status
• Blinking feature via the local display for simple device identification and
assignment
Administration of software options
Input/output value Process variable Category Slot
Output value Mass flow Process variable 1 to 14
Volume flow
Corrected volume flow
Density
Reference density
Temperature
Electronic temperature
Oscillation frequency
Frequency fluctuation
Oscillation damping
Oscillation frequency
Signal asymmetry
Exciter current
Empty pipe detection
Low flow cut off
Current device diagnostics
Previous device diagnostics
Output value Target mass flow Concentration
1)
1 to 14
Carrier mass flow
Concentration
Output value Oscillation damping 1 Heartbeat
2)
1 to 14
Заказывайте на сайте: www.tinnova.ru/endress_hauser/ || Эл. почта: info@tinnova.ru