Endress+Hauser Proline Promass E 100 - Mounting the Measuring Device

Proline Promass E 100
22 Endress+Hauser
Startup configuration
Startup configuration
(NSU)
If startup configuration is enabled, the configuration of the most important
device parameters is taken from the automation system and used.
The following configuration is taken from the automation system:
• Management
– Software revision
–
Write protection
• System units
– Mass flow
– Mass
– Volume flow
– Volume
– Corrected volume flow
– Corrected volume
– Density
– Reference density
– Temperature
– Pressure
• Concentration application package
– Coefficients A0 to A4
– Coefficients B1 to B3
• Sensor adjustment
• Process parameter
– Damping (flow, density, temperature)
– Flow override
• Low flow cut off
– Assign process variable
– Switch-on/switch-off point
– Pressure shock suppression
• Empty pipe detection
– Assign process variable
– Limit values
– Response time
– Max. damping
• Corrected volume flow calculation
– External reference density
– Fixed reference density
– Reference temperature
– Linear expansion coefficient
– Square expansion coefficient
• Measuring mode
– Medium
– Gas type
– Reference sound velocity
– Temperature coefficient sound velocity
• External compensation
– Pressure compensation
– Pressure value
– External pressure
• Diagnostic settings
• Diagnostic behavior for diverse diagnostic information
Заказывайте на сайте: www.tinnova.ru/endress_hauser/ || Эл. почта: info@tinnova.ru