Endress+Hauser Proline Promass E TB2 HART - Page 57

Proline Promass E TB2 HART Commissioning
Endress+Hauser 57
Parameter overview with brief description
Parameters Description Selection/
User entry
Factory setting
Assign current output 1-2 Select the process variable for
current output.
• Off (only for current
output 2)
• Mass flow
• Volume flow
• Corrected volume flow
• Density
• Reference density
• Temperature
• Current output 1: mass
flow
• Current output 2: off
Mass flow unit Select the unit for mass flow.
Result
The selected unit applies for:
– Current outputs
– Low flow cut off
– Simulation process
variable
Unit picklist Country-dependent:
• kg/h
• lb/min
Volume flow unit Select the unit for volume
flow.
Result
The selected unit applies for:
– Current outputs
– Low flow cut off
– Simulation process
variable
Unit picklist Country-dependent:
• l/h
• gal/min (us)
Density unit Select the unit for density.
Result
The selected unit applies for:
– Current outputs
– Low value partial filled
pipe detection
– High value partial filled
pipe detection
– Simulation process
variable
– Density adjustment (in the
Expert menu)
Unit picklist Country-dependent
• kg/l
• lb/cf
Corrected volume flow unit Select the unit for corrected
volume flow.
Result
The selected unit applies for:
– Current outputs
– Low flow cut off
– Simulation process
variable
Unit picklist Country-dependent:
• Nl/h
• Scf/min
Corrected volume flow
calculation
Select the reference density
for calculating the corrected
volume flow.
• Fixed reference density
• Calculated reference
density
Calculated reference density
Reference density unit Select the unit for reference
density.
Result
The selected unit applies for:
– Current outputs
– Low value partial filled
pipe detection
– High value partial filled
pipe detection
– Simulation process
variable
– Fixed reference density
– Density adjustment (in the
Expert menu)
Unit picklist
Country-dependent:
• kg/Nl
• lb/scf