Endress+Hauser Proline Promass E TB2 HART - Filtering the Event Logbook; Overview of Information Events

Proline Promass E TB2 HART Diagnostics and troubleshooting
Endress+Hauser 89
Calling up and closing the remedial measures
1. Press F.
Ã
The message for the remedial measures for the selected diagnostics event opens.
2. Press S + O simultaneously.
Ã
The message about the remedial measures closes.
•
About the structure of the remedial measure message (® ä 83)
•
For filtering the displayed event messages (® ä 89)
12.6.2 Filtering the event logbook
Using the Filter options parameter, you can define which category of event messages is displayed
in the Events list submenu.
Navigation path
Diagnostics ® Event logbook ® Filter options
Filter categories
• All
• Failure (F)
• Maintenance required (M)
• Function check (C)
• Out of specification (S)
• Information (I)
12.6.3 Overview of information events
Unlike a diagnostic event, an information event is displayed in the event logbook only and not in
the diagnose list.
Information
event
Event text
I1000 -------- (device OK)
I1079 Sensor changed
I1089 PowerOn
I1090 Configuration reset
I1091 Configuration modified
I1092 Data logging cleared
I1110 Write protection switch changed
I1111 Density adjust. error
I1137 Electronics changed
I1151 History reset
I1154 Minimum/maximum terminal voltage reset
I1155 Electronics temperature reset
I1156 Trend block memory error
I1157 Memory content events list
I1185 Device saved in display
I1186 Device with display restored
I1187 Measuring point copied via display
I1188 Display data cleared
I1189 Device backup compared
I1209 Density adjustment OK