Endress+Hauser Proline Promass F 100 - Commissioning; Function Check; Connecting via FieldCare; Configuring the Measuring Device

Commissioning Proline Promass F 100 Modbus RS485
52
10 Commissioning
10.1 Function check
Before commissioning the measuring device:
‣
Make sure that the post-installation and post-connection checks have been performed.
• "Post-installation check" checklist→  27
• "Post-connection check" checklist →  38
10.2 Connecting via FieldCare
• For FieldCare connection
• For connecting via FieldCare →  44
• For the FieldCare →  45 user interface
10.3 Setting the operating language
Factory setting: English or ordered local language
The operating language can be set in FieldCare or DeviceCare: Operation → Display
language
10.4 Configuring the measuring device
The Setup menu with its submenus contains all the parameters needed for standard
operation.

Setup
Device tag
→  53
‣
System units
→  53
‣
Medium selection
→  56
‣
Communication
→  57
‣
Low flow cut off
→  60
‣
Partially filled pipe detection
→  61
‣
Advanced setup
→  62