Endress+Hauser Proline Promass F 100 - Defining the Tag Name

Proline Promass F 100 Modbus RS485 Commissioning
53
10.4.1 Defining the tag name
To enable fast identification of the measuring point within the system, you can enter a
unique designation using the Device tag parameter and thus change the factory setting.
Enter the tag name in the "FieldCare" operating tool →  45
Navigation
"Setup" menu → Device tag
Parameter overview with brief description
Parameter Description User entry Factory setting
Device tag Enter the name for the measuring point. Max. 32 characters such as
letters, numbers or special
characters (e.g. @, %, /).
Promass
10.4.2 Setting the system units
In the System units submenu the units of all the measured values can be set.
Depending on the device version, not all submenus and parameters are available in
every device. The selection can vary depending on the order code.
Navigation
"Setup" menu → Advanced setup → System units
‣
System units
Mass flow unit
→  54
Mass unit
→  54
Volume flow unit
→  54
Volume unit
→  54
Corrected volume flow unit
→  54
Corrected volume unit
→  54
Density unit
→  54
Reference density unit
→  54
Temperature unit
→  55
Pressure unit
→  55