Endress+Hauser Proline Promass I 100 - Configuring the Totalizer

Proline Promass I 100 Modbus RS485 Commissioning
Endress+Hauser 53
Navigation path
"Setup" menu  Advanced setup  Sensor adjustment
Structure of the submenu
Sensor adjustment

Installation direction
Zero point adjustment

Zero point adjustment control
Progress
Parameter overview with brief description
Parameter Description Selection/
User entry
Factory setting
Installation direction Change the sign of the direction
of flow of the fluid.
• Flow in arrow direction
• Flow against arrow direction
Flow in arrow
direction
Zero point
adjustment control
Start the zero point adjustment. • Cancel
• Start
Cancel
Progress 0…100 % 0
10.4.4 Configuring the totalizer
You can configure each totalizer in the three submenus Totalizer 1-3.
Navigation path
"Setup" menu  Advanced setup  Totalizer 1-3
Structure of the submenu
Totalizer 1-3

Assign process variable
Mass unit
Volume unit
Corrected volume unit
Totalizer operation mode
Failure mode