11 Operation via FOUNDATION Fieldbus Proline Prowirl 72 FOUNDATION Fieldbus
88 Endress + Hauser
BLOCK_ERR Read only The active block errors appear on the display.
Display:
• OUT OF SERVICE
The block is in the "out of service" operating mode.
Block errors which are only shown in the Transducer Block "Diagnosis"
• SIMULATE ACTIVE
Simulation via the "Simulation - Measurand"
parameter (Page 101) in the Transducer Block "Flow" is active.
• MAINTENANCE NEEDED
The device must be checked since an active device error is pending.
A detailed display of the cause of the error can be called up in the
Transducer Block "Diagnosis" by means of the "Diagnosis - Actual
System Condition" parameter (Page 112).
UPDATE_
EVT
AUTO - OOS Indicates whether static block data have been altered, including date and
time.
BLOCK_ALM AUTO - OOS The current block status appears on the display with information on
pending configuration, hardware or system errors, including information
on the alarm period (date, time) when the error occurred.
! Note!
• In addition, the active block alarm can be acknowledged in this
parameter group.
• Prowirl 72 FF does not use this parameter to display a process alarm
since this is generated in the BLOCK_ALM parameter of the Analog
Input Function Block.
Transducer Type Read only The Transducer Block type appears on the display.
Display:
Standard flow with calibration
Transducer Error Read only The active device error appears on the display.
Possible display:
• No Error (normal status)
• Electronics Failure
• Data Integrity Error
• Mechanical Error
• Configuration Error
• General Error
! Note!
• The display of the device error is standardized. Precise information on
the error pending is available by means of the manufacturer-specific
error display which can be read off via the Transducer Block
"Diagnosis" in the "Diagnosis - Actual System Condition" parameter.
• An exact error description as well as information on rectifying errors
can be found on Page 49 ff..
FOUNDATION Fieldbus parameters (Transducer Blocks)
Parameter Write access for
operating mode
(MODE_BLK)
Description
To Next Page
Loading...
