Proline Prowirl 73 F, W
22 Endress+Hauser
Certification
FOUNDATION Fieldbus
The flowmeter has successfully passed all test procedures and is certified and registered by the Fieldbus
FOUNDATION. The device thus meets all the requirements of the specifications following:
• Certified according to FOUNDATION Fieldbus Specification
• The device meets all the specifications of the FOUNDATION Fieldbus-H1
• Interoperability Test Kit (ITK), revision status 4.5 (device certification no. available on request):
The device can also be operated with certified devices of other manufacturers
• Physical Layer Conformance Test of the Fieldbus FOUNDATION
Certification
PROFIBUS PA
The flowmeter has successfully passed all test procedures and is certified and registered by the PNO
(PROFIBUS User Organisation). The device thus meets all the requirements of the specifications following:
• Certified according to PROFIBUS PA profile version 3.0 (device certification number available on request)
• The device can also be operated with certified devices of other manufacturers (interoperability)
Other standards and
guidelines
• EN 60529: Degrees of protection by housing (IP code).
• EN 61010: Protection measures for electrical equipment for measurement, control, regulation and
laboratory procedures.
• EN 61326/A1: Electromagnetic compatibility (EMC requirements).
• NAMUR NE 21: Electromagnetic compatibility (EMC) of industrial process and laboratory control
equipment.
• NAMUR NE 43: Standardisation of the signal level for the breakdown information of digital transmitters
with analogue output signal.
• NACE Standard MR0175: Standard Material Requirements - Sulfide Stress Cracking Resistant Metallic
Materials for Oilfield Equipment.
• VDI 2643: Measurement of fluid flow by means of vortex flowmeters.
• ANSI/ISA-S82.01: Safety Standard for Electrical and Electronic Test, Measuring, Controlling and related
Equipment - General Requirements. Pollution degree 2, Installation Category II
• CAN/CSA-C22.2 No. 1010.1-92: Safety Standard for Electrical Equipment for Measurement and Control
and Labatory Use. Pollution degree 2, Installation Category II
• The International Association for the Properties of Water and Steam - Release on the IAPWS Industrial
Formulation 1997 for the Thermodynamic Properties of Water and Steam
• ASME International Steam Tables for Industrial Use (2000)
To Next Page
Loading...
