Endress+Hauser Proline Prowirl 73 - 4 Hardware Settings; Device Address

Hardware settings Proline Prowirl 73
20 Endress+Hauser
4 Hardware settings
This section only deals with the hardware settings needed for commissioning. All other settings
(e.g. output configuration, write protection, etc.) are described in the associated Operating
Instructions on the CD-ROM.
!
Note!
No hardware settings are needed for measuring devices with HART and
FOUNDATION Fieldbus-type communication.
4.1 Device address
Has to be set for measuring devices with the following communication methods:
• PROFIBUS PA
The device address can be configured via:
• Miniature switches  see description below
• Device functions/Operating program FieldCare  see Operating Instructions on the
CD-ROM