Endress+Hauser Proline Prowirl 73 - Software Settings; Troubleshooting

Commissioning Proline Prowirl 73
30 Endress+Hauser
5.5 Software settings
5.5.1 Device address
Has to be set for measuring devices with the following communication methods:
• PROFIBUS PA
Device address range: 0 to 126, factory setting 126
The device address can be configured via:
• Miniature switches  see Hardware settings  ä 20
• Device functions/Operating program FieldCare  see Operating Instructions on the CD-ROM
5.6 Troubleshooting
A complete description of all the error messages is provided in the Operating Instructions on the
CD-ROM.
!
Note!
The output signals (e.g. pulse, frequency) of the measuring device must correspond to the
higher-order controller.