Endress+Hauser Proline Prowirl 73 - Page 106

Description of device functions Proline Prowirl 73
106 Endress+Hauser
UNIT CALORIFIC
VALUE CORRECTED
VOLUME
Description
For selecting the unit required and displayed for the net calorific value based on the
corrected volume.
Options
SI:
kJ/Nm
3
MJ/Nm
3
kWh/Nm
3
MWh/Nm
3
US:
kJ/Sm
3
MJ/Sm
3
kWh/Sm
3
MWh/Sm
3
Btu/Scf
Factory setting
MJ/Nm
3
(SI units)
Btu/Scf (US units)
UNIT PRESSURE Description
For selecting the unit required and displayed for the pressure and the relative
pressure unit.
Options
bara (bar absolute)
psia (pounds per square inch absolute)
kPa a (Kilopascal absolute)
MPa a (Megapascal absolute)
kg/cm2 a (kilograms per square centimeter absolute)
mmH20(4°C) a (millimeter of water absolute)
inH20(39.2°F) a (inch of water absolute)
mmHg(0°C) a (millimeter of mercury absolute)
inHg(39.2°F) a (inch of mercury absolute)
Factory setting
See the parameter printout provided. The parameter printout is an integral part of these
Operating Instructions.
UNIT LENGTH Description
For selecting the unit required and displayed for the length unit of the nominal diameter
in the NOMINAL DIAMETER function (ä 171).
The unit you select here also affects:
• The unit in which the cable length is entered (ä 172)
• The unit of the velocity on the local display (ä 101)
Options
MILLIMETER
INCH
Factory setting
Depends on country ä 180
FORMAT DATE/TIME Description
Selection of the format of date and time. This indicates or must be entered, if the
calibration factor in function SENSOR DATA is changed (e.g. after a Re calibration).
Options
MM/DD/YY 24H
DD.MM.YY 24H
MM/DD/YY 12H A/P
DD.MM.YY 12H A/P
Factory setting
DD.MM.YY 24H
Function description, SYSTEM UNITS group