Endress+Hauser Proline Prowirl R 200 - Page 115

Proline Prowirl R 200 HART Commissioning
Endress+Hauser 115
Parameter Prerequisite Description Selection Factory setting
Totalizer operation mode – Select totalizer calculation
mode.
• Net flow total
• Forward flow total
• Reverse flow total
Net flow total
Failure mode One of the following options is
selected in the Assign process
variable parameter
(→  114) of the Totalizer
1 to n submenu:
• Volume flow
• Corrected volume flow
• Mass flow
• Total mass flow
*
• Condensate mass flow
*
• Energy flow
*
• Heat flow difference
*
Define totalizer behavior in
alarm condition.
• Stop
• Actual value
• Last valid value
Stop
* Visibility depends on order options or device settings