Endress+Hauser Proline Prowirl R 200 - Adapting the Measuring Device to the Process; Conditions; Performing a Totalizer Reset

Proline Prowirl R 200 HART Operation
Endress+Hauser 141
Navigation
"Diagnostics" menu → Measured values → Output values
‣
Output values
Output current 1
Measured current 1
→  141
Terminal voltage 1
→  141
Output current 2
Pulse output
→  141
Output frequency
→  141
Switch status
→  141
Parameter overview with brief description
Parameter Prerequisite Description User interface
Output current 1 – Displays the current value currently
calculated for the current output.
3.59 to 22.5 mA
Measured current 1 – Displays the current value currently
measured for the current output.
0 to 30 mA
Terminal voltage 1 – Displays the current terminal voltage
that is applied at the output.
0.0 to 50.0 V
Output current 2 – Displays the current value currently
calculated for the current output.
3.59 to 22.5 mA
Pulse output The Pulse option is selected in the
Operating mode parameter parameter.
Displays the pulse frequency currently
output.
Positive floating-point
number
Output frequency In the Operating mode parameter, the
Frequency option is selected.
Displays the value currently measured
for the frequency output.
0 to 1 250 Hz
Switch status The Switch option is selected in the
Operating mode parameter.
Displays the current switch output
status.
• Open
• Closed
11.5 Adapting the measuring device to the process
conditions
The following are available for this purpose:
• Basic settings using theSetup menu (→  75)
• Advanced settings using theAdvanced setup submenu (→  96)
11.6 Performing a totalizer reset
The totalizers are reset in the Operation submenu:
• Control Totalizer
• Reset all totalizers