Proline Prowirl R 200 HART Diagnostics and troubleshooting
Endress+Hauser 161
Info number Info name
I1514 Upload started
I1515 Upload finished
I1552 Failed: Main electronic verification
I1553 Failed: Pre-amplifier verification
I1554 Safety sequence started
I1555 Safety sequence confirmed
I1556 Safety mode off
12.9 Resetting the measuring device
Using theDevice reset parameter (→ 120) it is possible to reset the entire device
configuration or some of the configuration to a defined state.
12.9.1 Function scope of the "Device reset" parameter
Options Description
Cancel No action is executed and the user exits the parameter.
To factory defaults Every parameter is reset to its factory setting.
To delivery settings Every parameter for which a customer-specific default setting was ordered is reset
to this customer-specific value. All other parameters are reset to the factory
setting.
This option is not visible if no customer-specific settings have been ordered.
Restart device The restart resets every parameter whose data are in the volatile memory (RAM)
to the factory setting (e.g. measured value data). The device configuration remains
unchanged.
12.10 Device information
The Device information submenu contains all parameters that display different
information for device identification.
Navigation
"Diagnostics" menu → Device information
‣
Device information
Device tag
→ 162
Serial number
→ 162
Firmware version
→ 162
Device name
→ 162
Order code
→ 162
Extended order code 1
→ 162
To Next Page
Loading...
