Endress+Hauser Proline Prowirl R 200 - Mounting the Transmitter of the Remote Version

Proline Prowirl R 200 HART Installation
Endress+Hauser 31
Connecting the pressure measuring unit
6.
6.
7
7
A0035443
7 Device plug
6. Insert the plug for electrical connection of the pressure measuring cell and screw into
place.
6.2.5 Mounting the transmitter of the remote version
L
CAUTION
Ambient temperature too high!
Danger of electronics overheating and housing deformation.
‣
Do not exceed the permitted maximum ambient temperature .
‣
If operating outdoors: Avoid direct sunlight and exposure to weathering, particularly in
warm climatic regions.
L
CAUTION
Excessive force can damage the housing!
‣
Avoid excessive mechanical stress.
The transmitter of the remote version can be mounted in the following ways:
• Wall mounting
• Pipe mounting