Endress+Hauser Proline Prowirl R 200 - Turning the Display Module; Post-Installation Check

Proline Prowirl R 200 HART Installation
Endress+Hauser 33
max. 350°
8 mm
8 mm
1.
2.
3.
A0032242
1. Release the fixing screw.
2. Turn the housing to the desired position.
3. Firmly tighten the securing screw.
6.2.7 Turning the display module
The display module can be turned to optimize display readability and operability.
+
E
–
1
3 mm
1.
2.
3.
4.
A0032238
1. Loosen the securing clamp of the electronics compartment cover using an Allen key.
2. Unscrew cover of the electronics compartment from the transmitter housing.
3. Optional: pull out the display module with a gentle rotational movement.
4. Turn the display module to the desired position: max. 8 × 45° in every direction.
5. Without display module pulled out:
Allow display module to engage at desired position.
6. With display module pulled out:
Feed the cable into the gap between the housing and main electronics module and
plug the display module into the electronics compartment until it engages.
7. Reverse the removal procedure to reassemble the transmitter.
6.3 Post-installation check
Is the device undamaged (visual inspection)? 
Does the measuring device conform to the measuring point specifications?
For example:
• Process temperature →  191
• Process pressure (refer to the section on "Pressure-temperature ratings" in the "Technical
Information" document →  204)
• Ambient temperature
• Measuring range →  174
