Endress+Hauser Proline Prowirl R 200 - Page 78

Commissioning Proline Prowirl R 200 HART
78 Endress+Hauser
Parameter Prerequisite Description Selection Factory setting
Pressure unit With order code for "Sensor
version":
• option "Mass (integrated
temperature measurement)"
or
• option "Mass (integrated
pressure/temperature
measurement)"
Select process pressure unit.
Result
The unit is taken from:
• Calculated saturated steam
pressure
• Atmospheric pressure
• Maximum value
• Fixed process pressure
• Pressure
• Reference pressure
Unit choose list Country-specific:
• bar
• psi
Temperature unit – Select temperature unit.
Result
The selected unit applies for:
• Temperature
• Maximum value
• Minimum value
• Average value
• Maximum value
• Minimum value
• Maximum value
• Minimum value
• 2nd temperature delta heat
• Fixed temperature
• Reference combustion
temperature
• Reference temperature
• Saturation temperature
Unit choose list Country-specific:
• °C
• °F
Energy flow unit With order code for "Sensor
version":
• Option "Mass (integrated
temperature measurement)"
or
• Option "Mass (integrated
pressure/temperature
measurement)"
Select energy flow unit.
Result
The selected unit applies for:
• Heat flow difference
parameter
• Energy flow parameter
Unit choose list Country-specific:
• kW
• Btu/h
Energy unit With order code for "Sensor
version":
• Option "Mass (integrated
temperature measurement)"
or
• Option "Mass (integrated
pressure/temperature
measurement)"
Select energy unit. Unit choose list Country-specific:
• kWh
• Btu
Calorific value unit The following conditions are
met:
• Order code for "Sensor
version",
– Option "Mass (integrated
temperature
measurement)"
or
– Option "Mass (integrated
pressure/temperature
measurement)"
• The Gross calorific value
volume option or the Net
calorific value volume
option is selected in the
Calorific value type
parameter.
Select calorific value unit.
Result
The selected unit applies for:
Reference gross calorific value
Unit choose list Country-specific:
• kJ/Nm³
• Btu/Sft³