Endress+Hauser Proline Prowirl R 200 - Page 79

Proline Prowirl R 200 HART Commissioning
Endress+Hauser 79
Parameter Prerequisite Description Selection Factory setting
Calorific value unit (Mass) The following conditions are
met:
• Order code for "Sensor
version",
– Option "Mass (integrated
temperature
measurement)"
or
– Option "Mass (integrated
pressure/temperature
measurement)"
• The Gross calorific value
mass option or the Net
calorific value mass option
is selected in the Calorific
value type parameter.
Select calorific value unit. Unit choose list Country-specific:
• kJ/kg
• Btu/lb
Velocity unit – Select velocity unit.
Result
The selected unit applies for:
• Flow velocity
• Maximum value
Unit choose list Country-specific:
• m/s
• ft/s
Density unit – Select density unit.
Result
The selected unit applies for:
• Output
• Simulation process variable
Unit choose list Country-specific:
• kg/m³
• lb/ft³
Specific volume unit With order code for "Sensor
version":
• Option "Mass (integrated
temperature measurement)"
or
• Option "Mass (integrated
pressure/temperature
measurement)"
Select the unit for the specific
volume.
Result
The selected unit applies for:
Specific volume
Unit choose list Country-specific:
• m³/kg
• ft
3
/lb
Dynamic viscosity unit – Select dynamic viscosity unit.
Result
The selected unit applies for:
• Dynamic viscosity
parameter (gases)
• Dynamic viscosity
parameter (liquids)
Unit choose list Pa s
Length unit – Select length unit for nominal
diameter.
Result
The selected unit applies for:
• Inlet run
• Mating pipe diameter
Unit choose list Country-specific:
• mm
• in