Identification Proline t-mass 65 PROFIBUS DP/PA
10 Endress+Hauser
2.2 Certificates and approvals
The devices are designed in accordance with good engineering practice to meet state-of-the-art
safety requirements, have been tested, and left the factory in a condition in which they are safe to
operate. The devices comply with the applicable standards and regulations in accordance with
EN 61010-1 "Protection Measures for Electrical Equipment for Measurement, Control, Regulation
and Laboratory Procedures" and with the EMC requirements of IEC/EN 61326.
The measuring system described in these Operating Instructions thus complies with the statutory
requirements of the EC Directives. Endress+Hauser confirms successful testing of the device by
affixing to it the CE mark.
The measuring system meets the EMC requirements of the Australian Communications and Media
Authority (ACMA).
The flow measuring system has successfully passed all the test procedures carried out and is certified
and registered by the PNO (PROFIBUS User Organization).
The device thus meets all the requirements of the following specifications:
• Certified to PROFIBUS Specification, Profile Version 3.0
Device certification number: available on request
• The device can also be operated with certified devices of other manufacturers (interoperability)
2.3 Registered trademarks
KALREZ
®
and VITON
®
Registered trademarks of E.I. Du Pont de Nemours & Co., Wilmington, USA
PROFIBUS
®
Registered trademark of the PROFIBUS User Organization, Karlsruhe, Germany
HistoROM™, S-DAT
®
, T-DAT™, F-CHIP
®
, FieldCare
®
, Fieldcheck
®
, Applicator
®
, t-mass
®
Registered or registration-pending trademarks of Endress+Hauser Flowtec AG, Reinach, CH
To Next Page
Loading...
