Trouble-shooting Proline t-mass 65 PROFIBUS DP/PA
106 Endress+Hauser
9.6 Return
"
Caution!
Do not return a measuring device if you are not absolutely certain that all traces of hazardous
substances have been removed, e.g. substances which have penetrated crevices or diffused through
plastic.
Costs incurred for waste disposal and injury (burns, etc.) due to inadequate cleaning will be charged
to the owner-operator.
The following steps must be taken before returning a flow measuring device to Endress+Hauser,
e.g. for repair or calibration:
• Always enclose a duly completed "Declaration of contamination" form. Only then can
Endress+Hauser transport, examine and repair a returned device.
• Enclose special handling instructions if necessary, for example a safety data sheet as per
EC REACH Regulation No. 1907/2006.
• Remove all residues. Pay special attention to the grooves for seals and crevices which could
contain residues. This is particularly important if the substance is hazardous to health, e.g.
flammable, toxic, caustic, carcinogenic, etc.
!
Note!
You will find a preprinted "Declaration of contamination" form at the back of these Operating
Instructions.
9.7 Disposal
Observe the regulations applicable in your country!
9.8 Software history
!
Note!
Up or downloading a software version normally requires a special service software.
Date Software version Changes to software Operating Instructions
10.2010 3.06.XX Introduction of a new PROFIBUS PA I/O board
Software expansion:
– second gas group in memory
– gas heat flow and heat quantity
– variable gas fraction input
– revised diagnostics
– Fieldcheck compatibility
New functionalities:
– Quick Setups for gas, pressure, heat flow and
sensor
– additional pressure units
– system units for calorific value, heat flow and
quantity heat
– process pressure for gas group 1 + 2
– assignment of heat flow to display, totalizer
and outputs
– totalizer units for quantity heat flow
– assignment of gas groups to outputs and
totalizer
– selection special gas with correction factors
and reference density
– insertion depth calculator
– time stamping for process and system errors
71123860/13.10
11.2005 1.00.XX 71009069/12.05
To Next Page
Loading...
