Endress+Hauser Proline t-mass 65 - Accessories; Device-Specific Accessories; Measuring Principle-Specific Accessories

Proline t-mass 65 PROFIBUS DP/PA Accessories
Endress+Hauser 87
8 Accessories
Various accessories, which can be ordered separately from Endress+Hauser, are available for the
transmitter and the sensor. Detailed information on the order code in question can be obtained from
your Endress+Hauser representative.
8.1 Device-specific accessories
8.2 Measuring principle-specific accessories
Accessory Description Order code
Mounting boss Mounting boss for the t-mass insertion sensor
•G 1 A thread
•1" NPT female thread
DK6MB - ***
Cable remote Connecting cable for the remote version sensor and transmitter
(per m (ft), up to 100m (328ft) max.)
DK6CA - **
Transmitter t-mass 65 Transmitter for replacement or for stock. Use the order code to
define the following specifications:
•Approvals
• Degree of protection / version
• Cable entries
• Display / power supply / operation
•Software
• Outputs / inputs
65XXX-XXXXXX******
Accessory Description Order code
Mounting set for
transmitter
Mounting set for remote version. Suitable for:
– Wall mounting
– Pipe mounting
– Installation in control panel
Mounting set for aluminium field housing:
Suitable for pipe mounting (¾" to 3")
DK6WM - *
Flow conditioner Perforated plate flow conditioner:
• t-mass F sensor (DN25 to 100, 1"to 4")
• t-mass I sensor (DN80 to 300, 3" to 12")
DK6ST-***
DK7ST-***
Hot tap Mounting set with ball valve and safety chain. Insertion or
extraction of sensor under process pressure (max. 4 bar, 58 psi).
Please refer to the
product page of the
Endress+Hauser Internet
page:
www.endress.com
Mounting set with ball valve and spindle retractor. Insertion or
extraction of sensor under process pressure (max. 16 bar,
235 psi).
Graphic data manager
Memograph M
The graphic data manager Memograph M provides information on
all the relevant process variables. Measured values are recorded
correctly, limit values are monitored and measuring points
analyzed. The data are stored in the 256 MB internal memory and
also on an SD card or USB stick.
Memograph M boasts a modular design, intuitive operation and a
comprehensive security concept. The ReadWin® 2000 PC
software is part of the standard package and is used for configuring,
visualizing and archiving the data captured.
The mathematics channels which are optionally available facilitate
continuous monitoring, e.g. of specific energy consumption, boiler
efficiency and other parameters which are necessary for efficient
energy management.
RSG40 - ************