Commissioning Proline t-mass 65
24 Endress+Hauser
5.4 Calling the Commission Quick Setup
All the functions needed for commissioning are called up automatically with the Quick Setup.
The functions can be changed and adapted to the process in question.
1. F → Enter the function matrix (starting with measured value display)
2. P → Select the group QUICK SETUP
F → Confirm selection
3. QUICK SETUP COMMISSION function appears.
4. Intermediate step if configuration is blocked:
P → Enter the code 65 (confirm with F ) and thus enable configuration
5. P → Go to Commission Quick Setup
6. P → Select YES
F → Confirm selection
7. F → Start Commission Quick Setup
8. Configure the individual functions/settings:
– Via P-key, select option or enter number
– Via F-key, confirm entry and go to next function
– Via Q-key, return to Quick Setup Commission function
(settings already made are retained)
!
Note!
Observe the following when performing the Quick Setup:
• Configuration selection: Select the Actual Settings option
• Unit selection: This is not offered again for selection after configuring a unit
• Output selection: This is not offered again for selection after configuring an output
• Automatic configuration of the display: if YES is selected
– Main line = Mass flow
– Additional line = Totalizer 1
• If asked whether additional Quick Setups should be executed: select YES
All the available functions of the measuring device and their configuration options as well as
additional Quick Setups, if available, are described in detail in the "Description of Device
Functions" Operating Instructions. The related Operating Instructions can be found on the
CD-ROM.
The measuring device is ready for operation on completion of the following Quick Setups:
Commission, Sensor (only for 65 I), Gas, Pressure, Heat Flow (if used)
To Next Page
Loading...
