9 Trouble-shooting Promag 53 PROFIBUS-DP/-PA
122 Endress+Hauser
9.4 Spare parts
Chap. 9.1 contains a detailed trouble-shooting guide. The measuring device, moreover,
provides additional support in the form of continuous self-diagnosis and error
messages.
Fault rectification can entail replacing defective components with tested spare parts.
The illustration below shows the available scope of spare parts.
Note:
You can order spare parts directly from your E+H service organisation by providing the
serial number printed on the nameplates (Page 7 ff.).
Spare parts are shipped as sets comprising the following parts:
• Spare part
• Additional parts, small items (fasteners, etc.)
• Mounting instructions
• Packaging
Fig. 53: Spare parts for Promag 53 transmitter (field and wall-mount housings)
1 Power supply board
2 Amplifier board
3 I/O board (Type PROFIBUS-DP/-PA)
4S-DAT™ (sensor data memory)
5T-DAT™ (transmitter data memory)
6F-Chip™ (function chip for optional software)
7 Display module
8 Fieldbus connectors comprising protective cap, connector, adapter PG 13.5/M20.5
(only for PROFIBUS-PA, Order no. 50098037)
1
2
3
6
7
5
4
8
F06-53xPBxxx-03-06-06-xx-000
To Next Page
Loading...
