Endress+Hauser Promag 53 - Page 94

6 Commissioning Promag 53 PROFIBUS-DP/-PA
94 Endress+Hauser
Block model
The analog values transferred by Promag 53 during the cyclic data exchange are:
• Volume flow
• Totalizers 1-3 and the corresponding control parameters
• Calculated mass flow (see “Description of Device Functions” manual)
• Display value
• Control blocks for manufacturer-specific functions
The block model shows the input and output data which Promag 53 provides for data
exchange.
Fig. 52: Block model Promag 53 PROFIBUS-DP/-PA Profile 3.0
...
...
...
...
Local operation
COMMUNICATION
TA G
NAME
BUS
ADDRESS
WRITE
PROTECT
SELCTION
GSD
SET UNIT
TO BUS
PROFILE
VERSION
TOTALIZER
SELECT
TOTALIZER
TOTALIZER
OUT VALUE
CHANNEL
UNIT
TOTALIZER
SET
TOTALIZER
TOTALIZE
RESET
PRESET
PRESET
TOTALIZER
PROFIBUS-DP/PA
Signal processing
Transducer Block
DISPLAY VALUE
CONTROL
Value/Status
PROFILE
Parameter
Manufacturer
specific
parameter
Physical Block
Analog Input
Function block
OUT VALUE
Sensor
Value/Status
TOT. OUT VALUE
Value/Status
Totalizer
Function block
F06-50PBxxxxx-05-xx-xx-en-006