Appendix Prosonic M - FOUNDATION Fieldbus
84 Endress+Hauser
11.2 Block model of the Prosonic M
The Prosonic M contains the follwoing blocks:
• Resource Block (RB2)
s. Operating Instructions BA00013S: "FOUNDATION Fieldbus - Overview"
• Sensor Block (TBUL)
contains the parameters relevant to the measurement
• Diagnostic Block (DIAG)
contains the diagnostic parameters of the Prosonic M
• Display Block (DISP)
contains the configuration parameters for the display module VU331
• Analog-Input-Block 1 bzw. 2 (AI)
scale the signal of the Transducer Block and transmit them to the PLCS
• PID Block (PID)
s. Operating Instructions BA00013S: "FOUNDATION Fieldbus - Overview"
• Arithmetic Block (AR)
s. Operating Instructions BA00013S: "FOUNDATION Fieldbus - Overview"
• Input Selector Block (IS)
s. Operating Instructions BA00013S: "FOUNDATION Fieldbus - Overview"
• Signal Characterizer Block (SC)
s. Operating Instructions BA00013S: "FOUNDATION Fieldbus - Overview"
• Integrator Block (IT)
s. Operating Instructions BA00013S: "FOUNDATION Fieldbus - Overview"
11.2.1 Default Block configuration
The input and output variables of the blocks can be interconnected by a network configuration tool
(e.g. NI-Fieldbus configurator). The figure below shows, how these connections are set by default.
L00-FMU4XXXX-02-00-00-en-003
OUT
OUT
Physical Block
parameters of the
physical unit, e.g.
tag No.
Display
Sensor
signal evaluation
Sensor Block
Parameters that
describe the
device (calibration,
linearisation etc.)
Analog Input Function Block 1
parameters that are important to
the process control system,
e.g. scaling, status
Analog Input Function Block 2
parameters that are important to
the process control system,
e.g. scaling, status
PID Block
Automation
functions
Primary value
(main value)
Secondary value
(distance)
Third value
(temperature)
To Next Page
Loading...
