Mounting Prosonic M FOUNDATION Fieldbus
12 Endress+Hauser
2.5 Installation hint for FMU40/41
L00-FMU4xxxx-17-00-00-en-009
2.6 Turn housing
After mounting, the housing can be turned 350° in order to simplify access to the display and
the terminal compartment. Proceed as follows to turn the housing to the required position:
• Undo the fixing screws (1)
• Turn the housing (2) in the required direction
• Tighten up the fixing screws (1). Maximum torque 0.5 Nm (0.36 lbf ft).
• Loctite can be used for securing the screw.
60
AF 60
max torque
20 Nm (14.75 lbf ft)
Caution!
Use only the screw-in
piece to screw in
the Prosonic M
F12 or T12 housing
To Next Page
Loading...
