The "relays/controls" menu
116
5.3.8 The "operating hours alarm" submenu
A maximum run time can be defined for each pump. The operating hours alarm becomes active as
soon as this run time is exceeded.
"operating hours alarm N" (N = 1 or 2)
"operating hours alarm"
Use this parameter to switch the operating hours control on and off.
Selection:
• off (default)
•on
"alarm delay"
Defines the delay for the operating hours alarm. This delay is the same for all pumps.
Default: 0s.
"operating hours alarm N" (N = 1 or 2)
(pump selection)
Select the pump for which you are going to configure the operating hours alarm.
"operating hours N pump M" (N = 1 or 2, M = 1 - 6)
"operating hours"
Indicates how long the pump has been running since the last reset.
"maximum operating hours"
Defines the maximum running time of the pump. The operating hours alarm becomes active as soon
as "operating hours" exceeds this value.
Default: 10000 h
⇒
op.hours alarm1 R1612
op.hours alarm:
alarm delay:
⇒
op.hours alarm 1 R1613
pump 1:
pump 2:
...
⇒
op.hours alarm1 p1 R1613
operating hours:
max. op. hours:
To Next Page
Loading...
