Endress+Hauser Prosonic S FMU90 - 9.3 HART settings submenu (only for current output 1)

The "output/calculations" menu (for HART instruments)
132
L00-FMG60xxx-05-00-00-xx-012
1: measured value; 2: HART output value
6.4 "Simulation" submenu
6.4.1 "simulation"
"simulation"
Used to switch on the simulation of the current.
Selection:
• off (default)
No simulation is performed. The instrument is in the measuring mode.
• on
The instrument is in the simulation mode. No measured value is transmitted to the output.
Instead, the current output assumes the value specified in the "simulation value" subfunction.
"simulation value" (only for "simulation" = "on")
Specifies the value of the simulated output current (in mA).
5 x τ
t
L
1
2
⇒
simulation O1204
simulation:
simulation value: