Endress+Hauser Prosonic S FMU90 - The Envelope Curve Submenu; Plot Settings

The "system information" menu
147
9.5 The "envelope curve" submenu
This submenu can be used to display the envelope curve of the connected sensor on the display
module.
9.5.1 "envelope curve"
9.5.2 "Plot settings"
(Part 1: curve selection)
In this list, select which curves are to be displayed.
Selection:
• Envelop curve (default)
•Env. curve + FAC
• Envelope curve + customer map
9.5.3 "Plot settings"
(Part 2: single curve <-> cyclic change)
In this list, select the type of plotting.
Selection:
• single curve (default)
The envelope curve is plotted once.
• cyclic
The envelope curve display is updated in regular intervals.
!
Note!
If the cyclical envelope curve display is still active on the display, the measured value is updated at
a slower cycle time. We therefore advise you to exit the envelope curve display after optimising the
measuring point.
⇒
envelope curve IX126
en. curve sen. 1
en. curve sen. 2
In this list, select a sensor for the envelope curve display.
⇒
Plot settings IX127
Envelope curve
Env.curve+FAC
Env.curve+cust.map
⇒
Plot settings IX128
single curve
cyclic