The "flow" menu
47
"flow N level correction" (N = 1 or 2)
"offset"
This parameter can be used to shift the level by a constant value. The level entered into this para-
meter is added to the measured level.
"flow N" (N = 1 or 2)
Displays the currently measured flow in order to show the influence of the level correction on the
flow.
"flow N blocking distance" (N = 1 or 2)
"blocking distance"
Displays the blocking distance of the connected sensor.
"flow N limitation" (N = 1 or 2)
"limitation"
Use this parameter to specify if the measured value has a lower and/or upper limit.
Selection:
•off
• low limit
• high limit
• low/high limit
"upper limit"
Defines the upper limit for the measured value.
(only available for the options "high limit" and "low/high limit")
⇒
flow 1 level corr. F1013
offset:
flow 1:
⇒
flow 1 block. dist. F1015
blocking dist.:
⇒
flow 1 limitation F1014
limitation:
upper limit:
lower limit:
To Next Page
Loading...
