Endress+Hauser Prosonic S FMU90 - Page 60

The "flow" menu
60
3.2.4 The "simulation" submenu
"backwater simulation"
"simulation"
Use this parameter to select the simulation mode:
• sim. off
This is the normal mode used for measurement. No simulation is performed in this mode.
• sim. level
After selection of this mode, the "sim. level value" parameter appears, where you can specify a
level value. The backwater and dirt detection generate a ratio h
2
/h
1
according to this level.
!
Note!
An error message is generated as long as the "sim. level" mode is active.
"sim. level value"
This parameter is available for a level simulation. It is used ot specify the desired level value.
⇒
backw simulation F1600
simulation:
(sim. level value:)
The parameters of this set are used to simulate a downstream water
level in order to check the parametrisation of the backwater and dirt
detection.