Endress+Hauser Prosonic S FMU90 - 6.3 Preparing the basic setup

Commissioning Prosonic S FMU90 Flow Measurement PROFIBUS
54 Endress+Hauser
The table editor
L00-FMU90xxx-19-00-00-en-006
"status table" Use this parameter to enable or disable the linearization table.
Selection
•Enabled
The table is used.
• Disabled
The table is not used. The measured value is transferred to the output without
linearization.
1) This option is only valid for horizontal cylinders without dome ceiling. For tanks with dome ceiling FieldCare can
be used to calculate a linearization table and to upload it into the instrument.
Parameter Selection/Remarks
No.
Level
Value
1
0,0000
0,0000
2
0,0000
0,0000
3
0,0000
0,0000
…
0,0000
0,0000
: go tonext row
: go to previous row
: open marked row
for editing
No.
Level
Value
1
0,0000
0,0000
2
0,0000
0,0000
3
0,0000
0,0000
…
0,0000
0,0000
: navigate within the table
: (for "Level" und "Value”)
open marked number
for editing
: (for "No.")
open row editor
Rowfunction
(before current row)
Query: newposition
Return to the previous
stepbythis
key combination.
- Deleterow
- Insert row
- Moverow