Installation Prothermo NMT81
26 Endress+Hauser
5.9 Pre-installation of NMT81
5.9.1 Unpacking
Unpack NMT81 with multiple people. If NMT81 is unpacked by one person alone, the
temperature probe may become bent or twisted.
A0042787
14 Unpacking NMT81
5.9.2 Temperature probe handling
Do not pull the converter while holding onto the temperature probe. This may cause the
device to malfunction.
A0042788
15 Temperature probe handling
When winding the temperature probe, keep the bending diameter at a minimum of
600 mm (23.62 in). When installing the temperature probe onto a tank or if it is necessary to
bend the temperature probe, ensure that the bent portion is at least R = 300 mm (11.81 in).
To Next Page
Loading...
