Installation Prothermo NMT81
32 Endress+Hauser
5.11 Mounting NMT81 on a cone roof tank
When installing a WB probe, check "zero point" (reference position) on the WB probe by
comparing it to a manual dipping reference.
There are three ways to install NMT81 onto a cone roof tank:
• Top anchor method
• Stilling well method
• Anchor weight method
If a heating coil is attached to the bottom of the tank, install NMT81 so that the bottom
of the temperature probe or WB probe is not too close to the heating coil (distance varies
depending on the type of heating coil).
To Next Page
Loading...
