Endress+Hauser Prothermo NMT81 - Guidance

Prothermo NMT81 Commissioning
Endress+Hauser 57
7.4 Guidance
Guidance contains three items: Commissioning, Calibration, andImport / Export; however this
section only describes Commissioning and Import / Export. We recommend that calibration be
performed by E+H service personnel, and the procedures are therefore not listed in the
operating instructions.
7.4.1 Commissioning
Commissioning means to perform the initial settings for measurement. When the DTM is
opened for the first time, commissioning of NMT81 will be required.
Commissioning procedure
1. Navigate to: Guidance → Commissioning → Start

1
2
3
A0044587
 40 Initial screen of Commissioning
1 Home button
2 Operation menu: Guidance
3 Start button