Endress+Hauser ria45 - Quick Guide to Operating Matrix

RIA45 Operation
Endress+Hauser 17
In the event of an error:
The display shows: , the measured value is not displayed
Underrange/overrange:
The error and the channel identifier (TAG) are specified in the dot matrix section.
6.3.2 Icons in the editing mode
The following characters are available for entering customized text:
‘0-9’, ‘a-z’, ‘A-Z’, ‘+’, ‘-’, ‘*’, ‘/’, ‘\’, ‘%’, ‘°’, ‘2’, ‘3’, ‘m’, ‘.’, ‘,’, ‘;’, ‘:’, ‘!’, ‘?’, ‘_’, ‘#’, ‘$’, ‘"’, ‘´’, ‘(’, ‘)’,
‘~’
For numerical entries, the numbers ‘0-9’ and the decimal point are available.
Furthermore, the following icons are used in the editing mode:
Symbol for setup
Symbol for expert setup
Symbol for diagnostics
Accept entry.
If this symbol is selected, the entry is applied at the position specified by the user, and you quit editing
mode.
Reject entry.
If this symbol is selected, the entry is rejected and you quit editing mode. The previously set text
remains.
Jump one position to the left.
If this symbol is selected, the cursor jumps one position to the left.
Delete backwards.
If this symbol is selected, the character to the left of the cursor position is deleted.
Delete all.
If this symbol is selected, the entire entry is deleted.
6.4 Device configuration
Detailed information on the device configuration can be found in the Operating Instructions.