RIA452
Endress+Hauser 11
Operating elements Jog shuttle
Remote operation Configuration
The device can be configured with the PC software ReadWin
®
2000.
Interface
TDL interface at device; connection to PC via USB box (see 'Accessories')
RS232 interface at device; connection with serial interface cable (see 'Accessories')
Certificates and approvals
CE mark The device meets the legal requirements of the EU directives. Endress+Hauser confirms that the device has
been tested successfully by affixing the CE mark.
Ex approval Information about currently available Ex versions (ATEX, FM, CSA, etc.) can be supplied by your E+H Sales
Centre on request. All explosion protection data is given in a separate documentation which is available upon
request.
Other standards and guideli-
nes
• IEC 60529:
Degrees of protection by housing (IP code)
• IEC 61010-1:
Protection measures for electrical equipment for measurement, control, regulation and laboratory procedu-
res
• CSA 1010.1
Safety requirements for electrical equipment for measurement, control, and laboratory use - General require-
ments
• FM 3610
Intrinsically safe apparatus and associated apparatus for use in class 1, 2 and 3, division 1 hazardous (classi-
fied) locations
• CSA C22.2.157
Intrinsically safe & non-incendive equipment for use in hazardous locations
• CSA E79-11
Electrical apparatus for explosive gas atmospheres - intrinsic safety ’i’
• EN 50020
Electrical apparatus for hazardous areas - intrinsic safety ’I’
To Next Page
Loading...
