Endress+Hauser Smartec S CLD132 - Mounting CLD132 separate version

Smartec S CLD132 Installation
Endress+Hauser 15
3.4 Installation instructions
3.4.1 Mounting CLD132 separate version
Wall mounting
For wall mounting, attach the mounting plate to the wall by drilling holes as required. Anchors and
screws are to be provided by the operator.
C07-CLD132-11-06-00-en-007.eps
Fig. 11: Wall mounting of CLD132 separate version
Post mounting
A mounting kit for installing the housing on horizontal or vertical posts or pipes (max. Ø 60 mm /
Ø 2.36") is available as an accessory (see chapter "Accessories").
C07-CLD132xx-00-06-06-001.eps
Fig. 12: Mounting kit for installing the CLD132 separate version on posts
1. Remove the mounting plate.
2. Insert the holding bars through the pre-drilled holes of the mounting plate and screw the
mounting plate onto the transmitter.
3. Use the brackets to install the Smartec S on the post or pipe (Fig. 13).
225 / 8.86
160 / 6.30
∅ 7 / 0.28
mm / inch