Endress+Hauser Waterpilot FMX21 - Post-Connection Check; 7 Operation Options; Overview of Operating Options

Waterpilot FMX21 Operation options
Endress+Hauser 31
6.6.2 Connecting the Commubox FXA195
See the Operating Instructions.
6.6.3 Connecting the Field Xpert SFX
See the Operating Instructions.
6.6.4 Connecting for air pressure compensation with external measured value
See the Operating Instructions.
6.6.5 Connecting an external temperature sensor/temperature head transmitter for
density compensation
See the Operating Instructions.
6.7 Post-connection check
 Is the device or cable undamaged (visual check)?
 Do the cables comply with the requirements ?
 Do the cables have adequate strain relief?
 Are all cable glands installed, securely tightened and leak-tight?
 Does the supply voltage match the specifications on the nameplate?
 Is the terminal assignment correct ?
7 Operation options
Endress+Hauser offers comprehensive measuring point solutions with display and/or
evaluation units for the Waterpilot FMX21 HART and TMT182 temperature head transmitter.
Your Endress+Hauser service organization would be glad to be of service if you have any
other questions. Contact addresses can be found on the website at
www.endress.com/worldwide
7.1 Overview of operating options
7.1.1 Operation using Endress+Hauser operating program
See the Operating Instructions.
7.1.2 Operation via Field Xpert SFX
See the Operating Instructions.
7.1.3 Operation via RIA15
The RIA15 can be used as a local display unit and for the basic configuration of the Waterpilot
FMX21 hydrostatic level sensor via HART.