Endress+Hauser Waterpilot FMX21 - For Selecting the Pressure Engineering Unit

Waterpilot FMX21 Commissioning
Endress+Hauser 35
Measuring mode
Navigation Setup → Measuring mode
Write permission Operator/Service engineers/Expert
Description Select the measuring mode.
The operating menu is structured differently depending on
the measuring mode selected.
Options • Pressure
• Level
Factory setting Level
9.5 For selecting the pressure engineering unit
Press. eng. unit
Navigation Setup → Press. eng. unit
Write permission Operator/Service engineers/Expert
Description Select the pressure engineering unit. If a new pressure
engineering unit is selected, all pressure-specific
parameters are converted and displayed with the new unit.
Options • mbar, bar
• mmH2O, mH2O, inH2O
• ftH2O
• Pa, kPa, MPa
• psi
• mmHg, inHg
• kgf/cm
2
Factory setting mbar or bar depending on the nominal measuring range of
the sensor module, or as per order specifications.