Endress+Hauser Waterpilot FMX21 - 14.14 Expert→ Communication → HART Output

Description of device parameters Waterpilot FMX21
106 Endress+Hauser
14.14 Expert→ Communication → HART output
Primary value is
Write permission No write permissions. Parameter is read only.
Description Indicates which measured value is transmitted via the HART protocol as the primary
process value.
Factory setting Depending on the selected measuring mode, the following measured values can be
displayed:
• "Pressure" measuring mode: "Meas. pressure"
• "Level" measuring mode, Lin. mode "Linear": "Level before Lin"
• "Level" measuring mode, Lin. mode "Activate table": "Tank content"
Primary value
Write permission No write permissions. Parameter is read only.
Description The primary value is displayed.
Secondary val.is
Write permission No write permissions. Parameter is read only.
Description Indicates which measured value is transmitted via the HART protocol as the secondary
process value. The process value is configured via HART command 51.
Factory setting • "Pressure" measuring mode: "Corrected press."
• "Level" measuring mode, "Linear" lin. mode: "Meas. pressure"
• "Level" measuring mode, Lin. mode "Activate table": "Level before linearization"
Display Depending on the selected measuring mode, the following measured values can be
displayed:
• "Meas. pressure"
• "Sensor pressure"
• "Corrected press."
• "Pressure after damping"
• "Sensor temp."
• "Level before Lin"
• "Tank content"
• "Process density" (corrected)
Secondary value